Eau Claire, WI · Northwestern Wisconsin Closed now (715) 450-9897

Track and Athletic Surfaces in Bloomer

Track and Athletic Surfaces in Bloomer, Wisconsin.

Track and court resurfacing for schools in and around Bloomer, scheduled into the summer window.

4.7 from 18 Google reviews

About 30 minutes north of Eau Claire. Free estimates, and a straight read on whether it needs doing yet.

A resurfaced asphalt running track with crisp white lane lines, painted lane numbers and colored exchange markings, playing field beyond.
3,646 People in Bloomer
4.7 Google ratingFrom 18 reviews
2-3 yrs Reseal cycleIn Bloomer
400°F Crack fillerDirect-fire rubber

What a Track and Athletic Surfaces Job Looks Like in Bloomer

There are two commercial zones and they behave differently. Main Street is the historic downtown, tight lots with shared access and on-street parking, where the jobs are small and access is tight.

The highway strip along Seventeenth and Nineteenth Avenue is the other one: modern retail, larger lots, purpose-built parking and room to work. Bloomer also carries real medical parking for a town this size, on more than one street, plus industrial ground on the edges. Those are the square-footage jobs.

Track and Athletic Surfaces specifically in Bloomer

School and community courts. Bloomer runs a genuinely well-used recreation program for its size, and those surfaces get booked into the summer window alongside everything else the district has scheduled while the buildings are empty. Being half an hour north also shortens that window at the back end, so a court booked for September here is tighter than the same date would be in Eau Claire.

The Lots and Surfaces in Bloomer

Bloomer sits north of Chippewa Falls where Highways 40 and 64 cross, the largest town in the northern half of the service area and the one most of the smaller places up there drive to.

Bloomer

We work the whole village rather than a named handful of neighborhoods.

Around Bloomer: Main Street, Highway 40 and 64 junction, Bloomer Middle School.

Standard 48-inch frost depth, and far enough north that spring opens a week later than it does in Eau Claire.

From our jobs

Job Photos

A resurfaced running track with fresh white lane lines, painted lane numbers and yellow exchange marks
Lane lines and numbers, back on after resurfacing
A resurfaced running track curve with white lane lines and colored relay exchange zone markers
Relay exchange zones, measured and marked

All job photos

What makes track work different

The surface work is the same trade. Clean it, fill what has opened up, seal it, and it lasts. What's different is everything downstream of the paint gun. Lane lines are set from a measured stagger so that every lane runs the same distance. Exchange zones and acceleration zones have defined lengths and have to be marked in the right colors to be read at speed. Get the layout wrong and you have a facility that looks finished and can't host a meet, which is a problem nobody notices until the day it matters.

What Decides the Price in Bloomer

These are ranges. Anything at this scale is walked and measured before it is quoted, because condition and layout move the number far more than square footage does.

Restripe only

Existing layout, surface sound

Measured on site

  • Lanes, exchange and acceleration zones, numbers
  • Layout taken from the existing measured stagger

Courts

Tennis, basketball, pickleball

Measured on site

  • Per court, depending on condition and color coating
  • Multiple courts on one visit come down per court

Public bodies usually need a bid they can put against a budget line, often a season ahead. Ask in the fall for work the following summer and you'll get a better number and a better slot.

How the Work Goes in Bloomer

Track work happens in the summer window between seasons.

Walk it, measure it, write it

Condition survey and a measured check of the existing layout before anything is quoted. If the stagger has drifted from an earlier restripe, that gets found now rather than after the paint is down.

Crack repair

Hot rubber at 400 degrees into anything that has opened up. On a track this matters more than on a lot, because a crack across a running lane is a trip hazard as well as a leak.

Clean and seal

The whole surface, edge to edge. This is the step that buys the years and it is the one that gets deferred, because a faded track still works.

Lay out the lines

Chalked from measurements, checked, then painted. Lanes, exchange and acceleration zones, start lines, and lane numbers.

Hand it back clean

Cured, swept, and ready for the season.

Questions We Get in Bloomer

What Bloomer calls us about, answered straight.

More questions answered
When does the season actually start up here?
About a week later than it does in Eau Claire, and it closes a little sooner at the other end. Sealer needs the surface dry and the overnight temperature to stay up, and thirty minutes north is enough to move both. The practical answer is that fall work booked ahead beats waiting on a northern April.
Can you work a Main Street lot without closing us for the day?
Usually, but it's the first thing to talk about rather than the last. The downtown lots here are tight with shared access, so a section at a time is often the only way to keep a door open. Sealer needs about 24 hours before traffic goes back on it, and that's the constraint the schedule gets built around.
Is Bloomer far enough north that the drive costs us something?
Bloomer is about thirty minutes north and it's well inside the area we work. The estimate is free, and the number you approve is the number you pay.
When can track work be done?
Summer, between seasons. Sealer needs warm dry weather and a proper cure, and a track needs to be closed while that happens, so the window is roughly June through August in Bloomer and the surrounding area. Book in the winter for the following summer.
How often does an asphalt track need resealing?
Every three to five years for the seal, and crack filling as often as it needs it, which in Bloomer and the surrounding area is usually annually on an older track. Lines get relaid with the seal, because sealing over them removes them.
Can you restripe a track without resurfacing it?
Yes, and it is often the right call when the surface is sound and only the lines have faded. It buys a few years before the surface work is genuinely due. What it costs depends on the layout: lane count, whether the exchange zones and the field events are being reinstated, and whether the existing lines can be followed or have to be set out again.
Do you do tennis, basketball and pickleball courts?
Yes. Same trade, smaller and simpler layout. Multiple courts done on one visit cost less per court because the trip is already paid for.
Can you put track and court work out as a formal bid?
Yes. Written scope, measured quantities and a firm number, in whatever format your district needs it, and early enough to sit in next year's budget.

Get a Free Estimate in Bloomer

Tell us what it looks like and we'll come measure it. You get a written price before anything starts.

(715) 450-9897
  • Free on driveways and lots anywhere in the service area
  • A photo of the problem helps, and it can go in the message
  • Surfaces that are not ready yet get told so at the estimate

Get an estimate

Send the form and we'll call you back. The estimate is free.