Asphalt Repair and Patching in Bloomer
Asphalt Repair and Patching in Bloomer, Wisconsin.
Pothole, patch and sinkhole repair in Bloomer, cut back to sound material and rebuilt properly.
About 30 minutes north of Eau Claire. Free estimates, and a straight read on whether it needs doing yet.

What an Asphalt Repair and Patching Job Looks Like in Bloomer
There are two commercial zones and they behave differently. Main Street is the historic downtown, tight lots with shared access and on-street parking, where the jobs are small and access is tight.
The highway strip along Seventeenth and Nineteenth Avenue is the other one: modern retail, larger lots, purpose-built parking and room to work. Bloomer also carries real medical parking for a town this size, on more than one street, plus industrial ground on the edges. Those are the square-footage jobs.
Asphalt Repair and Patching specifically in Bloomer
The industrial ground on the edges of town takes loading the retail strip doesn't, and it fails differently: rutting and edge break-up rather than potholes. Both get cut square and rebuilt to the base rather than skimmed. Downtown the repairs are smaller and fiddlier, because Main Street lots are tight with shared access and there's rarely somewhere to put a machine that isn't in somebody's way.
The Driveways and Lots in Bloomer
Bloomer sits north of Chippewa Falls where Highways 40 and 64 cross, the largest town in the northern half of the service area and the one most of the smaller places up there drive to.
Bloomer is the most evenly built town in the service area. No single decade carries it: about a third of the stock predates 1960, but nearly a quarter has gone up since 2000, and every decade in between is represented.
That matters more than it sounds. In a town built in one burst, the driveways all fail together and the advice is largely the same. In Bloomer the house next door can be thirty years older than yours, and what its drive needs isn't what yours needs. We quote them separately rather than by neighborhood.
Bloomer
We work the whole village rather than a named handful of neighborhoods.
Around Bloomer: Main Street, Highway 40 and 64 junction, Bloomer Middle School.
Standard 48-inch frost depth, and far enough north that spring opens a week later than it does in Eau Claire.
Filled vs. repaired
The pothole that comes back every spring is being filled rather than repaired. Cold patch is a temporary measure and an honest one when it's sold as that: it's loose material tamped into a hole, with no bond to the sides and nothing done about the failed base underneath. It gets you through a winter. A real repair means cutting a clean square back to material that's still sound, taking out everything soft below it, putting the base back and compacting it in lifts, then laying hot asphalt and rolling it. The patch ends up stronger than what is around it, which is why the failure doesn't come back through the middle of it.
Filled
The quick version
- Cold patch tamped into the hole as found
- Ragged edges, so there's nothing to key against
- Failed base left in place
- Back within a season, usually wider
Repaired
What we do
- Saw cut to clean vertical edges, back to sound asphalt
- Soft material dug out until the bottom is firm
- Base replaced and compacted in lifts
- Hot mix laid, rolled, and the joint sealed
Cold patch has its place: it's the right call in February when nothing else can be done. It's the wrong call in July.
What Decides the Price in Bloomer
Repairs are priced by area and by how deep the trouble goes, and the depth isn't knowable until it's open. These are the bands most jobs land in.
Single pothole
Up to a few square feet
Measured on site
- Saw cut, dig out, base, hot mix, compact
- Cheaper alongside other work
Failed area or apron
Roughly 50 to 300 sq ft
Measured on site
- The common commercial repair, and the garage apron at home
- Priced per square foot once the area is measured
Sinkhole or subgrade failure
Depth unknown until opened
Measured on site
- Often a drainage or utility problem underneath
- Assessed and quoted before the machine moves
Several repairs on one visit come down substantially per repair, because getting the machine and the crew on site is most of the cost of a small one. If you have three, have them all looked at.
Repair or repave?
Most lots that get deferred don't need repaving.
What we look at before quoting either one.
- Two or three potholes, the rest of the surface is soundStraightforward patching. Nowhere near needing an overlay. Repairable
- The garage apron has sunk where it meets the concreteCommon and fixable. Usually settlement under the transition, cut out and rebuilt. Repairable
- Cracked into squares in a few areas, sound elsewhereCut those areas out full depth, patch, then seal the whole surface. Repairable
- That squared cracking across most of the lotThe base has gone broadly. Patching it becomes a rolling cost with no end. An overlay or a rebuild is the answer. Needs replacement
- Water sits in the same spot after every rainGrade or drainage, and it has to be solved before any surface work, or the new surface fails in exactly the same place. Depends, send a photo
Photos of the worst two areas are usually enough for us to tell you which it is.
How the Work Goes in Bloomer
Same method on a driveway apron and on a loading dock approach.
Find the edge of the failure
The visible hole is smaller than the damage. We sound out where the surface is still supported and cut outside that, not around the hole.
Saw cut square, clean vertical faces
A patch keyed against a clean edge stays. A patch feathered against a ragged one fails at the joint, which is why so many patches fail in a ring.
Dig out to something firm
Everything soft comes out. If the bottom is wet, that's a drainage problem and the best patch in the world won't last sitting on water.
Base back in, compacted in lifts
Compacted in layers rather than dumped and rolled once. This is the invisible step that decides whether the repair lasts two years or twenty.
Hot mix, rolled, joint sealed
Laid to the surrounding grade so water still runs where it's supposed to, compacted, and the perimeter joint sealed against the next freeze.
When does the season actually start up here?
Can you work a Main Street lot without closing us for the day?
Is Bloomer far enough north that the drive costs us something?
How much does pothole repair cost?
Why does my patch keep failing?
Can you repair a sinkhole in a driveway or lot?
Is it cheaper to repair the asphalt or repave it?
How soon can we drive on a new asphalt patch?
Get a Free Estimate in Bloomer
Tell us what it looks like and we'll come measure it. You get a written price before anything starts.
(715) 450-9897- Free on driveways and lots anywhere in the service area
- A photo of the problem helps, and it can go in the message
- Surfaces that are not ready yet get told so at the estimate
Get an estimate
Send the form and we'll call you back. The estimate is free.
Other Work We Do in Bloomer
- Sealcoating in Bloomer
- Crack Filling and Sealing in Bloomer
- Catch Basin Repair in Bloomer
- Parking Lot Striping in Bloomer
- Track and Athletic Surfaces in Bloomer
- Concrete in Bloomer
- Asphalt Paving in Bloomer
- Commercial Snow Removal in Bloomer
Asphalt Repair and Patching in Nearby Towns
- Asphalt Repair and Patching in Chippewa Falls
- Asphalt Repair and Patching in Colfax
- Asphalt Repair and Patching in Lake Hallie
- Asphalt Repair and Patching in Chetek
- Asphalt Repair and Patching in Cornell
- Asphalt Repair and Patching in Elk Mound
Everything about asphalt repair and patching, including how the work goes and what changes the price



